I have finally decided how to handle uneven battles without
having to set up and play the boring and predictable wargame.
There has been some suggestions from the campaign players on
the PBEM forum, and I have taken that into consideration. Mind a lot of it would not fit into the
campaign system, so I have had to compromise .
I considered a chart for each corps involved, but decided against
that as it would involve too much work.
I would have to take quality of commanders, plus the quality, ability,
casualties and morale of each brigade. All
of this would require a large chart of plus and minus points, and would need
constant adjustment in the light of game experience.
I have decided to stick with one simple chart. However I will use two D6 dice to cover a
wider range of possibilities.
A low dice total indicates that the weaker side has managed
to retreat before the stronger side can bring their weight to bear. Only the rearguard has been involved in the
fighting, which has been light and ineffective.
The higher the total the more fighting has taken place. Both sides suffer casualties, but the weaker
side many more than the stronger side.
This simple solution will save a lot of time fighting
pointless and boring wargames.
It also follows the same principle as my wargame rules. A low dice is bad luck for the attacker. A high dice bad luck for the defender.
Even in the worse case the casualties will not be sufficient
to force the weaker side to surrender. I
would not want any campaign to end without a formal wargame to decide the
winner.
On the other hand the weaker side will always suffer more
casualties than the stronger side. This
was not always the case when we fought the battle as a wargame. The weaker side would always retreat as soon
as they saw that the attackers were much stronger. They would often do so without any
casualties at all.
The new chart is as follows
Roll two D6 dice
Total Stronger
Side Weaker Side
02 1
infantry 1 infantry
03 1
infantry 2 infantry
04 1
infantry 2 infantry 1 cavalry
05 1
infantry 3 infantry
06 2
infantry 3 infantry 1 cavalry
07 2
infantry 4 infantry
08 2
infantry 4 infantry 1 cavalry
09 2
infantry 5 infantry
10 3
infantry 5 infantry 1 cavalry 1 gunner
11 3
infantry 6 infantry
12 3
infantry 6 infantry 1 cavalry 1 gunner
Note
1 infantry equals 400 infantry casualties
1 cavalry equals 100 cavalry casualties
1 gunner equals 100 gunners casualties and three guns
Each full strength corps has 16000 infantry, 1000 cavalry
and 1000 gunners.
So possible casualties of 2400 infantry, 100 cavalry and 100
gunners is a considerable punishment for allowing yourself to be attacked
by greater numbers of the enemy.
This will allow me to avoid wargaming uneven battles. No doubt I will encounter problems as I use
it in the campaign, but at least I can forget the problem for now